How To Install A Septic Tank Pump

Septic alarms point when the septic tank pump is not operating. There are several pumps used in a septic tank. A septic tank system volition always have a grinder pump. The grinder pump is used to grind all the waste from the house into smaller pieces that tin be broken downwards by the bacteria in the septic tank. There may be a riser pump installed also in the septic system if it lies on a colina or if the drain field is located above the septic tank.

If whatsoever of these pumps fail, the septic tank system is no longer operational. The pump must be replaced promptly to foreclose overflow or drainage problems. Hither are the steps to replace a septic tank pump.

Step 1 - Identify Pump to Exist Replaced

If the waste material pieces are not existence broken downwardly into smaller pieces, the pipes in the bleed field will get chock-full. This may result in sewage backup up in the basement of the house or having toilets backed up and slow to bleed. If this is happening then the grinder pump needs to exist replaced. The riser pump moves the waste product from the septic tank into the drain field. If waste is not being carried to the drain field, the riser pump is broken. The pump gets its name because it "raises" the waste product to the college drain field.

Step 2 - Buy the Correct Pump

Besides the grinder pump and the riser pump, at that place is also a sump pump. Do non confuse the sump pump with the correct pump that you need to buy. A grinder pump volition have an internal wheel that will grind the waste product every bit it passes through it. A riser pump volition push the waste material through the pipes to the higher level. Make sure that you purchase the correct pump.

Step three - Remove Broken Pump

Most grinder pumps are located in the basement of a house continued to the drain pipe that flows into the septic tank system. The pump will accept electrical wiring attached to it. The electrical wiring will need to be disconnected before you lot can install the new pump. It is recommended to disable the electricity at the electrical panel before removing the wiring.

Stride 4 - Install Alarm System

Any new grinder pump is required to have an alarm system with information technology. This alarm is required by city and county sewer codes. The alarm will sound if there is a problem with the level of wastewater in the septic tank, which alerts the homeowner to a potential trouble with the septic organisation. The alarm will be required to exist installed on a divide breaker organization from the pump. It may be necessary to run new electrical wires for the alert system to the electrical console and install a new breaker. Local building codes may require an inspector to inspect the installation of any new electrical wires.

Step 5 - Install New Pump

The new pump will require its own electrical organization. The new pump should be connected to the electric system where the faulty pump wiring was removed. Although not recommended, you lot tin install waterproofing effectually the new pump to protect it from water. One time the new pump is installed the septic tank system will be operational.